Bent Over Low-Pulley Side Lateral
A beginner isolation movement that trains the shoulders with a cable machine.
Force Type
Pull
direction of effort
Difficulty
Beginner
training level
Variations
0
equipment swaps
Muscles
4
primary + secondary
The verdict
Bent Over Low-Pulley Side Lateral has 5-step instructions, more thoroughly documented than most of the 127 shoulders exercises PlainExercise catalogues.
Ranked against the 127 shoulders exercises PlainExercise currently catalogues, not the full exercise-science literature.
Catalog lens
Two ways this record sits in the source corpus
These are placement measures for the documented record, not a score for exercise quality, safety, or suitability.
Instruction steps
#180 of 868
More thorough than most
Numbered source steps, ranked across every documented exercise.
Instruction text
#327 of 868
Typical documentation depth
A separate character-length placement prevents step count from standing in for explanatory detail.
Bent Over Low-Pulley Side Lateral vs every catalogued exercise by instruction-text length
Where this record's instruction-character count sits among all 873 Free Exercise DB exercises with instructions, not a rating of the movement itself.
715 327th of 873 higher than 545 of 873 exercises
All exercises, banded by instruction-text character count
Each bar is a band; taller bars hold more exercises. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count and share, and where it sits relative to this entry.
Source Free Exercise DB · 2026-07-10
Bent Over Low-Pulley Side Lateral is documented from the Free Exercise DB (CC0) extract, last ingested July 2026. Classification, muscle roles and instruction text are source facts; the placement and cohort measures on this page are computed by PlainExercise and are not a rating of the movement.
What the Bent Over Low-Pulley Side Lateral Data Reveals · DEEP · PULL/ISOLATION
Bent Over Low-Pulley Side Lateral stands out on mechanic class: joint involvement separates this page from isolation peers.
Longer step lists usually mean finer setup cues, not a harder movement by themselves.
Across 127 catalogued shoulders movements, the average instruction record is 623 characters and 4.2 steps; 82 of those (64.6%) clear the same ≥500-character rich bar used here. This page ranks #45 of 127 by instruction-character length (1.15× the cohort average).
Among the 81 exercises that also use a cable machine, average instruction length is 786 characters; 47 of those peers are longer than this record. Equipment-matched peers are the honest comparison when you are choosing a substitute implement for the same pattern.
Other well-documented shoulders movements (same ≥500-character bar):
- Clean and Jerk (8 steps, 2,551 chars)
- Clean and Press (7 steps, 1,667 chars)
- Cable Seated Lateral Raise (7 steps, 1,233 chars)
- External Rotation (6 steps, 1,212 chars)
- Reverse Flyes With External Rotation (7 steps, 1,105 chars)
Context matters: taxonomy (level, mechanic, force, musculature, equipment) does not account for individual biomechanics, joint history, or recovery. Common-mistake framing below is derived from classification fields, not case-specific coaching. Not medical or personal-training advice. Consult a physician or certified trainer before starting, especially with injuries, cardiovascular conditions, recent surgery, or pregnancy.
Bent Over Low-Pulley Side Lateral catalog footprint
Among 127 exercises whose primary muscle is shoulders, Bent Over Low-Pulley Side Lateral ranks #43 by catalogued variation count. The upstream file attaches 2 images to this slug. See the step-count ranking for shoulders for peer documentation depth.
Muscles worked
The Free Exercise DB classifies each muscle as primary or secondary. It does not measure activation, so we show involvement, not percentages.
Source: Free Exercise DB primary/secondary muscle classification. Actual recruitment varies by load and form.
Intensity context
For reference, here is where common activities sit on the MET intensity scale. Bent Over Low-Pulley Side Lateral does not have a measured MET in the source data, its intensity depends on the load and effort you use. Estimate calories for any activity with the calorie calculator.
MET values from the Compendium of Physical Activities (Ainsworth et al., 2011). A general reference scale, not a rating of this specific movement.
How to do it
- Select a weight and hold the handle of the low pulley with your right hand.
- Bend at the waist until your torso is nearly parallel to the floor. Your legs should be slightly bent with your left hand placed on your lower left thigh. Your right arm should be hanging from your shoulder in front of you and with a slight bend at the elbow. This will be your starting position.
- Raise your right arm, elbow slightly bent, to the side until the arm is parallel to the floor and in line with your right ear. Breathe out as you perform this step.
- Slowly lower the weight back to the starting position as you breathe in.
- Repeat for the recommended amount of repetitions and repeat the movement with the other arm.
Common mistakes
- Rushing through reps before the pattern is grooved - at this stage, a slow, controlled tempo (2-3s down, 1-2s up) on Bent Over Low-Pulley Side Lateral teaches the nervous system the movement far faster than speed does.
- Cutting the range of motion short - moving the shoulders through its full safe range on Bent Over Low-Pulley Side Lateral is what most reliably separates effective reps from wasted ones.
- Using momentum instead of muscle, isolation movements like Bent Over Low-Pulley Side Lateral reward strict form. If you're swinging the weight, it's too heavy.
- Shrugging the shoulders up toward the ears on pull movements, keep shoulder blades down and back to load the correct muscles.
- Breathing out of sync with the lift on Bent Over Low-Pulley Side Lateral - brace and inhale during the lowering phase, exhale on the exertion, especially important with a cable machine where control matters most.
Who this is for
- People new to resistance training who want to build a foundation in the movement pattern
- People who want to train the Shoulders and secondarily lower back, middle back
- People who have access to a cable machine
Who this is NOT for
- People hunting equipment swaps, this record has none to offer; browse the peer shoulders exercises for alternate patterns instead.
- Anyone with acute pain in the joints or muscles involved, pain is a stop signal, not a soreness signal
- People with unresolved injuries in the loaded joints, seek clearance from a physical therapist first
- Anyone with a recent surgery, cardiovascular limitation, or pregnancy complication without physician clearance
Progression path
Once Bent Over Low-Pulley Side Lateral feels comfortable with your current load, progress by (a) adding reps until you can complete 12+ per set, (b) increasing resistance by 2.5-5%, (c) moving to harder variations such as single-limb or longer lever versions, and eventually (d) stepping up to intermediate-level movements that train the same muscle.
See the Progression guide for a full framework on when to advance, and the Compound vs Isolation guide to decide when to prioritize this movement in your program.
Safety notes · CABLE · PULL/ISOLATION · FLOOR
- On PULL/ISOLATION shoulders work, warm up 5–10 minutes before loading Bent Over Low-Pulley Side Lateral; keep first sets light until the path feels automatic.
- Sharp or joint pain is a stop signal. Muscle soreness during sets is normal; pain is not.
- Beginners on CABLE gear: cut volume before cutting form, drop a set rather than rush reps.
- General information only. Consult a physician or certified trainer before starting any new exercise program.
Curated workout appearances
Bent Over Low-Pulley Side Lateral is not currently featured in one of the 186 curated workout routines on this site.
Nationwide exercises with similar documentation depth
Two Free Exercise DB peer sets for Bent Over Low-Pulley Side Lateral, drawn across all muscles (not the shoulders-only related list below). Each metric produces a different neighborhood.
Similar instruction step count
Nearest catalog records by numbered steps.
Similar instruction text length
Nearest catalog records by upstream instruction characters.
Related exercises
Other exercises that target the Shoulders.
See all Shoulders exercises.
Using the bent over low-pulley side lateral
Three ways to put it to work.
- Train the shoulders 2–3 times a week with 48+ hours between hard sets; pair this with other shoulders movements for balanced development. All shoulders exercises
- Match the load and rep range to your goal, strength, size, or endurance each call for a different scheme. Strength vs hypertrophy
- As an isolation movement, use it to target the shoulders directly after your compound lifts. Compound vs isolation
Form before load. If a movement causes sharp or joint pain, stop and substitute a safer alternative, this is general information, not medical or training advice.